CAT4106AGEVB: DC-DC Converter LED Driver Evaluation Board

The CAT4106 DC/DC converter is capable of driving up to 4 strings of LEDs with tight matching. This device is designed to drive LED strings up to 36 V. The LED brightness is set by a single resistor from the RSET pin to GND and PWM dimming is available via the EN/PWM pin. Additional information can be found in the CAT4106 data sheet.

The CAT4106EVAL1 board contains one CAT4106 in a typical application circuit. The board can be powered in two different ways. With the J1 jumper in place a single high voltage supply (6 V to 24 V) can be applied between VL and GND. A circuit on board will generate a lower, regulated voltage for the VIN pin (6.2 V - VGS of transistor M1). VIN can also be powered separately by removing the J1 jumper and applying a second voltage to the VIN test point. The voltage at VIN should not exceed 6.0 V.
製品 状態 Compliance 簡単な説明 使用パーツ アクション
CAT4106AGEVB Active
DC-DC Converter LED Driver Evaluation Board CAT4106HV4-GT2
Avnet (2017-02-19) : 2
タイプ ドキュメント・タイトル ドキュメント ID/サイズ 修正
Eval Board: BOM CAT4106AGEVB Bill of Materials ROHS Compliant CAT4106AGEVB_BOM_ROHS.PDF - 45 KB  0 
Eval Board: Gerber CAT4106AGEVB Gerber Layout Files (Zip Format) CAT4106AGEVB_GERBER.ZIP - 46.0 KB  0 
Eval Board: Schematic CAT4106AGEVB Schematic CAT4106AGEVB_SCHEMATIC.PDF - 130 KB  0 
Eval Board: Test Procedure CAT4106AGEVB Test Procedure CAT4106AGEVB_TEST_PROCEDURE.PDF - 21 KB  0 
Eval Board: Manual CAT4106 LED Driver Evaluation Board User's Manual EVBUM2024/D - 124.0 KB  1 
Video DC-DC Converter LED Driver Evaluation Board - CAT4106AGEVB Test Procedure WVD17057/D   

DC-DC Converter LED Driver Evaluation Board - CAT4106AGEVB Test Procedure