Change History

RSL15 Hardware Reference:

• Recommended voltage for using LDO clarified
• Added more details on calibrating the 32 kHz crystal oscillator
• More default antenna number details

General:

• Improvements made to Search function in HTML documentation set

RSL15 Getting Started Guide:

• EmbSys Register View and Peripheral Register plugins documented
• Minimum recommended J-Link version updated

RSL15 Firmware Reference:

• Description of new function Device_RF_SetMaxPwrIdx() added
• Added guidance on reducing APP_RWIP_HEAP_DB_SIZE RAM size

RSL15 Getting Started Guide:

• IAR Embedded Workbench instruction section added
• Minimum required J-Link version specified for all supported IDEs
• Location of onsemi IDE installation instructions/Release Notes specified

RSL15 Hardware Reference:

• Warning added about bandgap voltage at extreme temperatures
• Added summary of ACS_AOUT_CTRL register
• Safe access to ACS while using the RTC documented
• Pull resistor details added to GPIO section
• Added information about minimum wakeup delay configurations
• Cross-references added from Hardware Reference topics to relevant information in the HAL section of the Firmware Reference

RSL15 Firmware Reference:

• Boot options, including warm boot, documented in the Program ROM section
• Application Validation and Boot information added to Program ROM section
• Additional Bluetooth Low Energy support macros added in Bluetooth GAP section

Secure Bootloader Guide:

• New information for Secure FOTA

Device Firmware Update Guide:

• New information for Secure FOTA
• Added information for using Bluetooth Low Energy FOTA
• Required Android version updated

RSL15 Developer’s Guide:

• Added section on CMSIS-Pack component structure
• Added section on best practices for handling faults and watchdog timer resets

General:

• Added a note on Welcome Page to help users who cannot see the side navigation bar in HTML documentation